HOW TO WIRE ADAFRUIT TRINKET 5V GUIDE PORTABLE

Carefully cut the trace between them with a hobby knife and replace with two wires from a switch like the slide switch, or a pushbutton one, for example.Ĭharging is performed in three stages: first a preconditioning charge, then a constant-current fast charge and finally a constant-voltage trickle charge to keep the battery topped-up.

The two 0.1' holes with a box around them are the battery output line. If you want to add an On/Off switch, we also made that really easy. When the battery is fully charged and ready for use, the green LED turns on. There are two LEDs - one red and one green. Solder the backpack on with the extra long header so that it can still plug into a breadboard, or clip the long header leads short afterwards for a slim package. (Technically its overclocking but we've never seen that affect the Pro Trinket itself, AVRs are happy to overclock without complaint).

However, many times, you can run a 5V Pro Trinket + accessories off of the ~4V from the LiPoly battery with no problem. Ideally, this backpack is for use with the 3.3V Pro Trinket, so that the battery voltage (3.7V-4.2V) will get regulated down to 3.3V on the Pro Trinket board. Unplug the USB port and the Pro Trinket will switch over to the rechargeable battery. When the Pro Trinket USB port is powered, the battery is recharged automatically. This LiPoly backpack makes it really easy to do! Instead of wiring 2 or 3 boards together to make a charging system, this little PCB sits on top of the Pro Trinket and allows a LiPoly/LiIon battery to plug in.

HOW TO WIRE ADAFRUIT TRINKET 5V GUIDE PORTABLE

If you have a Pro Trinket you probably know it's the perfect little size for a portable project.

How to wire adafruit trinket 5v guide